The DLS-30 Power Converter/Battery Charger from IOTA Engineering converts nominal 108-132 AC voltage to 13.4 DC voltage for both DC load operation and 12V battery charging.
As a power supply, the unit’s tightly controlled regulation allows the user to operate a nominal 12VDC load up to 30 amps.
As a battery charger, the unit will maintain the battery, delivering its full-rated current when the battery capacity falls sufficiently low. The voltage is set to deliver its maximum current for the necessary period of time to minimize undue stress to the battery caused by heating of its cells. This helps to ensure the longest possible life of the battery. Over time, as the battery nears its full capacity, the DLS-30 will automatically drop the current, providing a float-charge to the battery to prevent self-discharge of the cells.
The SBI12-LLD is a microprocessor-controlled Load Disconnect Isolator. The SBI12-LLD is designed specifically for use in LiFePO4 battery applications as a system to protect the lithium battery from being excessively discharged by auxiliary loads, enabling the auxiliary battery to remain above the level at which internal protection circuitry would activate. Falling below this threshold would prevent many chargers from recharging the battery.
Roto-molded gas can that is durable with thicker walls and stronger construction make it leak-proof along with a sure seal gasket to guarantee your spout wont leak or vibrate loose. Rotopax are the only rotationally molded EPA and CARB compliant containers available for sale in the United States. This is thanks to a patented three layer Roto-Molding process, along with specialty formulated plastic barrier material to meet the governments new extremely low permeability requirements.
PLEASE ALWAYS REMEMBER TO VENT THE FUEL PACK ONCE PER DAY IF THE ELEVATION OR TEMPERATURE CHANGES SIGNIFICANTLY.
This is crucial when you have water in your truck camper. When you’re done using your camper, open up the petcock to drain all the water from the fresh water tank.
This is crucial when you have water in your truck camper. When you’re done using your camper, open up the petcock to drain all the water from the fresh water tank.
Achieve a safe and stable entry to your Four Wheel Pop Up Truck Camper with the original GlowStep system. These steps are extraordinarily sturdy by connecting the camper all the way to ground level.
Achieve a safe and stable entry to your Four Wheel Pop Up Truck Camper with the original GlowStep system. These steps are extraordinarily sturdy by connecting the camper all the way to ground level.
Make getting in and out of your camper easier with these 6-step accordion aluminum scissor steps. Built from aircraft-grade aluminum and stainless steel for durable, slip-resistant performance on any adventure.
Attwood 12V trolling motor plug is a molded rubber connector that attaches directly to the trolling motor. Comes with three 6″ 10 gauge wire pigtails with butt connectors.
The Bugout 130™ Portable Solar Generator is built to withstand the harshest conditions rain or shine, whether you are a clumsy over-lander or depend on mission-critical power for military operations. The Bugout 130™ is the solar power system of choice for thousands of RV and Camper owners, Overland Expeditions as well as government agencies and remote site operations.
This portable solar kit generates enough power for most vehicle-based and small camper applications, putting up to 7 amps per hour into the battery. When paired with our Solar Charge Controller, it will rapidly charge any 12-Volt battery.
In contrast to flexible solar systems, the Bugout 130™ Portable Solar Kit was designed to provide massive increases in power in a lightweight field-expedient kit. The solar performance is unrivaled, generating power even in rain and snow.
Proudly made by us in Boise, Idaho the Bugout 130™ is all-weather big power when you need to charge much more than phones, tablets, and the GPS. The kit includes a 20-foot extension cable with SB50 and SAE connectors to plug into your camper solar plug, Dometic PLB40 Battery Pack, and other common portable battery systems.
These lightweight extension plates attach to your jack brackets and extend your jacks out. This is crucial for trucks that have wide tires or fender flares. Using the extension plates extends the jacks out 3″.
Disposal issues resolved! WAG™ Bags can be used with any portable toilet system or by themselves. No Cleaning, No Dumping, No Hassle. Each WAG bag kit contains an outer zip-close disposal bag, waste bag preloaded with Pooh-Powder, toilet paper and a hand sanitizer. Non-toxic Pooh-Powder treats up to 32 oz. of liquid and solid waste allowing for multiple use. It turns liquid waste to a solid for hygienic and spill proof transport. The Poo Powder waste treatment controls odors and contains a decay catalyst that breaks down solid waste. Double-Bag System is made from puncture resistant materials. WAG bag kits are Bio-degradable and are approved for disposal in any garbage can. 12 waste kits. Made in USA.
Enjoy dignified convenience with our safe, sturdy, thoughtfully engineered, premium quality GO anywhere portable toilet®. Our compact toilet weighs just 7 pounds and folds closed to standard briefcase size. It provides the comfort, height and ease of use of a standard toilet, supports up to 500 pounds and is stable on uneven ground. No mixing, messy chemical waste storage tanks or dump stations required. No assembly required.
